Dacor DECT365 Installation Manual download pdf (Page 6)

Step 2

Place a towel or table cloth onto the counter top. Lay

the cooktop upside down onto the protected surface.

BURNER BOX

TABLE CLOTH

Figure 6

Step 3

A foam tape is provided to seal the cooktop edges to

the countertop.

Apply tape approximately 1/16" (1.5 mm) from the

glass edge to the underside of the cooktop glass. Use

tape around the entire glass perimeter. Cut off excess

where tape ends butt.

BURNER BOX

FOAM TAPE

SEAL

COOKTOP GLASS

Figure 8

Step 5

Four clamp brackets are provided to clamp the cooktop to

the countertop. Tighten screws just enough to hold brackets

in place when cooktop is put into cutout. Tighten screws

securely.

Figure 9

Figure 7

Step 4

Insert the cooktop centered into the cutout opening. Make

sure the front edge of the counter top is parallel to the

cooktop. Make final check that all required clearances are

met.

1 2 3 4 5 6 7 8 9 10

No comments

Dacor DECT365 Installation Manual Page 6