Dacor ER3OD Specifications download pdf (Page 11)

Changing the Backguard (models ER30D

and ER3OD-C only)

Models ER30D and ER30D-C come standard with a 3" backguard

installed• The 6" and 9" backguards are optional•

To change the backguard:

1. Remove and retain the three (3) chrome screws on the front

of the existing backguard.

2. Remove and retain the two (2) upper screws on the back of

the side panels.

3. Slide the existing backguard off the unit.

Installing the ATK3OSR Raised Vent Trim

(model ER3ODSRonly)

To install the optional raised vent with self-rimming model

ER30DSR, you must install the optional raised vent trim kit.

Kit

To change the trim on model ER30DSR:

1. Remove and retain the seven (7) chrome screws that hold

the existing trim pieces in place.

2. Slide the existing trim pieces off the range.

4. Place the new backguard over the back of the range.

5. Fasten the backguard using the five (5) existing screws.

New backguard,

height varies

3. Slide the new trim pieces onto the range•

4. Fasten the new trim pieces in place using the existing screws•

Installing the ARSP3 3-Inch Side Panel Kit

(model ER3ODSRonly)

For self-rimming installations with non-standard countertop

depths, installation of the optional side panel kit may be necessary

to cover the sides of the range that protrude from the cabinet.

To install the side panel kit:

1. Open the oven door. Remove and retain the two (2) screws

on the top of the kick panel. The screws are accessed

through the space between the door and the oven opening.

Space between

door and oven

opening _ Remove and

retain screws

Continued...

dacar 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

No comments

Dacor ER3OD Specifications Page 11