Dacor Range DR30D-C User Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
23
Care and Cleaning
WARNING
Clean only the parts of the range listed in this •
manual. Clean them only in the manner specified.
To avoid dangerous fumes or damage to your •
range’s surfaces and accessories, use only the types
of cleaning solutions specified in this manual.
To avoid burns, make sure that all parts are cool •
before cleaning.
To prevent damage, do not use abrasive or •
corrosive cleaners or applicators such as steel wool
or scouring pads, on any part of the range unless
instructed to do so. Use only a sponge, soft cloth,
fibrous or plastic brush, or nylon cleaning pad for
cleaning the surfaces of your range.
Do not use a steam cleaner to clean the range. •
Steam could penetrate the electrical components
and cause a short circuit.
Do not try to remove heavy spills with a sharp •
object such as a knife or metal spatula. Sharp
objects may scratch your range’s surfaces.
Your Oven’s Self Clean Feature
About the Self Clean Cycle
The oven will run better and produce better baked •
goods when it is clean. During self cleaning, the oven
is heated to very high temperatures which burn off
any deposits on the surfaces of the oven. Self cleaning
eliminates the need for manual scrubbing of interior
surfaces. The self clean process takes about three
hours.
It is normal for the oven to emit smoke during the •
first few self clean cycles. It is also normal for the
oven to emit popping sounds during self cleaning.
These sounds are caused by the expansion and con-
traction of metal surfaces when the oven heats up and
cools down.
The self clean process takes about three hours.•
Self clean mode will not function if the meat probe is •
connected.
WARNING
Always wipe up excess grease and other food spills •
with a damp cloth prior to using the self clean
cycle. Doing so will minimize smoke and increase
efficiency. See the proper cleaning instructions on
this page.
Do not touch the outside surfaces of the oven •
during the self clean cycle. They will be hot.
Racks, the convection filter, meat probe or any •
other items left in the oven during self cleaning will
become damaged or damage the oven. See page 26
for directions for polishing a rack that is left in the
oven accidently during self cleaning.
How to Use the Self Cleaning Feature
Before self cleaning the oven, remove the racks, the 1.
convection filter, all cookware (pots, pans, forks, etc.),
the meat probe, foil and any other loose objects from
the oven chamber. See page 27 for instructions on
how to remove and clean the filter.
Clean soil from the porcelain surfaces of the door 2.
outside of the door gasket. Rinse surfaces well with
a solution of vinegar and water, then wipe dry. Heav-
ily soiled areas may be cleaned with a non-scratching
scouring pad.
Clean the door gasket by dabbing it with a solution of 3.
water and mild soap.
WARNING
Use caution when cleaning the door gasket. Rubbing •
or displacing it may damage the tight door seal
required for proper cooking and self cleaning.
Do not try to force the door open after it is locked. •
Damage to the door or latch may result.
Turn on kitchen fans or vents to help remove odors 4.
during the self clean cycle.
Make sure the oven door is shut.5.
Press the 6. SELF CLEAN key, then press START.
The control panel automatically locks the oven door
during self cleaning. The latch prevents the door from
being opened since the high interior oven temperatures
can easily cause injury. If the door is not shut, an error
message will appear on the display. To correct the prob-
lem, press CANCEL
· SECURE and wait approximately one
minute, then close the door. When the door is properly
closed, start the self clean process again.
The display shows the self clean cycle status:
The clean symbol indicates that self clean is in •
process.
The lock symbol indicates that the door is •
latched.
• ON” indicates that the heating elements are on.
If you want to stop the self clean cycle, press the CANCEL
· SECURE key. The oven door will remain locked until it is
safe enough to open. The lock symbol will disappear from
the display when the door lock is released. You will still
need to exercise caution when the door lock is released
because the inside of the oven may still be hot.
After the self clean cycle is complete:
The door latch will release when the inside has cooled •
down. The clean icon, lock icon and “ON” will disap-
pear from the display. Exercise caution because the
oven will still be hot (about 400°F) at the time the
door lock is released.
Reinstall the convection filter and oven racks before •
using your oven.
You may notice a powder ash residue in the bottom •
of the oven after self cleaning. This is normal. Use a
damp cloth or sponge to wipe up the residue after the
oven cools down. Continued...
1 2
1 2
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comments to this Manuals

No comments