Installation InstructionsRenaissance® Series Gas CooktopModels RNCT305G, RNCT365GPart No. 109386 Rev. A
8Verifying the Package Contents• Hold-down brackets (2)• Grates: (3)• Burner sets: (5)• Gas pressure regulator: (1)• Stainless steel cleaner: (1)
9Installation InstructionsAssembling the Burners WARNING• Never attempt to operate the cooktop with any of the burner parts removed.• Do not attempt
10Installation InstructionsIMPORTANT: Assemble the grates as instructed below. When installed correctly, the openings in the grates are centered over
11Installation InstructionsVerifying the Correct Setup WARNING• Make sure that power to the electrical outlet is turned off at the circuit breaker pa
10Installation InstructionsInstallation Checklist WARNINGTo ensure a safe and proper installation, the following checklist should be completed by the
11Wiring Diagrams WARNINGLabel all wires prior to disconnection when servicing controls. Miswiring can cause malfunction and dangerous operation.Verif
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com
Downdraft Compatibility ...6 Verifying the Package Contents ...8Installing
1Important Information About Safety Instructions• The Important Safety Instructions and warnings in these instructions are not meant to cover all pos
2Important Safety Instructions• Read the accompanying use and care manual com-pletely before operating this appliance.• Keep packaging materials awa
3Electrical Requirements WARNINGTo prevent an electric shock hazard, the power supply must meet the specifications stated below. It is the own-er’s re
4Installation Specifications WARNINGObserve all governing codes and ordinances during planning and installation. Contact your local building departmen
5Installation SpecificationsRNCT305G and RNCT365GSurface vs Chassis Overhang DimensionsA2" (5.1 cm)from countertop to cooking surface21"(53.
6Cabinet and Countertop Layout WARNING• To reduce the risk of personal injury caused by reaching over a hot appliance, avoid locating cabinet storage
7Installation SpecificationsCutout DimensionsCooktop with Downdraft: ERV SeriesCountertop Cutout DimensionsAll tolerances +1/16” -0” (+1.6 mm) unless
Comments to this Manuals