Dacor EWD27 Operations Instructions download pdf (Page 9)

Pushinontab

Slide mounting bracket

under clip on slide

Clip on slide

Pull up on T

drawer front

/

Slide

Push drawer front

down until tab locks

in place

Drawer Removal Drawer Installation

....

Problem Solution Guide

::_J_ PROBLEM MAYBE CAUSEDBY WHAT TO DO

Nothing works.

Drawer does not slide smoothly

or drags.

Excessive condensation,

One or more of the indicator

lights on the control panel blink

on and off (one second on, one

second off).

Power plug disconnected.

Timer is not set.

Warming drawer is not connected

to power.

Tripped circuit breaker or blown

fuse.

Ambient temperature below 32°F

(ooc).

Drawer is incorrectly mounted into

slide mechanism.

Drawer is over-loaded or the load

is unbalanced.

Warming drawer not preheated.

Incorrect humidity control setting.

The control panel computer has

detected an error:

#1 - Temperature error

#2 - Sensor error

#3 - Key pad error

#4 - Control error

Connect plug to a dedicated, grounded, three-

prong electrical outlet.

Select time duration according to the

Operating Znstructions section.

Plug the warming drawer into a 120 Vac,

15 Amp., dedicated electrical outlet.

Check the circuit breaker panel or fuse box

tripped breaker or blown fuse.

Temperature around warming drawer must be

above freezing.

Remount drawer into slide, per instructions

above

Reduce the weight to less than 50 pounds.

Redistribute drawer contents

Preheat the warming drawer before each use

Set humidity control to CRISP to allow mois-

ture to vent

Try resetting the computer. Disconnect the

power cord, wait 20 seconds, then reconnect

it. Check the control panel. If the indicator

light still flashes, call for service. See page 8

7

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments