Dacor MRWD27 User Manual download pdf (Page 8)

Care and Cleaning

caution

To prevent permanent damage to the appliance •

surfaces, do not use abrasive cleaners or scrubbers.

Do not allow acids (citrus juices, tomato sauces, •

etc.) to remain on the warming drawer’s surfaces.

The finish may stain.

Do not try to remove heavy spills with a sharp object •

such as a knife or metal spatula. Sharp objects may

scratch the surfaces.

Always wipe stainless steel surfaces in the direction •

of the grain.

Control Panel

Clean the control panel with a soft cloth soaked with a

solution of mild detergent and hot water. Rinse and dry

with a soft cloth. Exercise caution to avoid introduction of

liquids into the area behind the control panel. Do not use

abrasive cleaners or scrubbers. They may permanently

damage the nish or scrap off the letters and graphics.

Moist • Crisp Control

Clean the Moist • Crisp lever with a solution of mild deter-

gent and hot water. Rinse and dry with a soft cloth.

Drawer Handle

Clean the drawer handle with a solution of mild detergent

and hot water. Rinse and dry with a soft cloth.

You may also use Dacor Stainless Steel Cleaner. It is

available from your Dacor dealer. Use it according to the

directions on the package.

Always wipe stainless steel surfaces in the direction of the

grain.

Glass Surfaces

Clean all glass surfaces with a solution of mild detergent

and hot water. You may also use a mild glass cleaner to

remove ngerprints or smears. Dry completely with a soft,

lint-free cloth.

Brass and Chrome Surfaces

Clean brass and chrome surfaces with a solution of mild

detergent and warm water. Rinse, dry and polish with a

soft, lint-free cloth.

You may also use Dacor Stainless Steel Cleaner. It is

available from your Dacor dealer. Use it according to the

directions on the package.

Painted Surfaces

For the front face of warming drawers with a painted

nish, clean with a solution of mild detergent and hot

water. Rinse and dry with a soft cloth. Do not use abrasive

cleaners or scrubbers. They may permanently damage the

nish.

Gasket

The gasket is located around the edge of the drawer

opening, below the control panel.

Gently clean the gasket with a solution of mild detergent

and hot water. Rinse and dry with a soft cloth. The gasket

material is soft, so be careful not to crush or damage

it. Damaging the gasket will cause a poor heat seal and

result in poor warming drawer performance.

Drawer Slides

The warming drawer has slides positioned on each side

of the drawer. They allow the drawer to slide in and out

smoothly. Remove the drawer from the slides to make

cleaning easy or to access the serial number plate. The

drawer slides themselves do not require maintenance.

Removing the Drawer from the

Appliance

Allow the drawer to cool before attempting to remove it.

Pull the drawer out to the fully open position. 1.

Push in on the locking tab on one side as you pull the 2.

drawer up. See the facing page.

When the drawer comes loose from the slide, repeat 3.

the same process on the opposite side.

Grip the drawer on both sides and pull it free.4.

For safety, push both drawer slides into the drawer 5.

opening.

Reinstalling The Drawer

Pull the1. drawer slides all the way out of the drawer

opening.

Gently lower the drawer between the extended slides 2.

until it is suspended by them.

Slide the back of the drawer mounting brackets under 3.

the clips on the slides. See the facing page.

Push one side of the drawer down onto its locking tab, 4.

until the tab locks into place.

R5. epeat the same process on the opposite side.

Gently open6. and close the drawer to make sure that it

is properly installed.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Dacor MRWD27 User Manual Page 8

Comments to this Manuals

Related products and manuals for Warming drawers Dacor MRWD27