Dacor ERV3615 Specifications

Installation InstructionsDowndraft Raised VentModel ERV3615Part No. 107000 Rev. AUse these downdraft raised vents only with approved Dacor ® applianc

82. Cut and remove the foil material inside the knock-out hole. If you fail to remove the foil, the vent will not work.3. If the unit will vent thro

95. Gently slide the vent into the rear of the countertop cut-out with the electrical access panel toward the front.6. Loosely attach the anchoring

10Installation InstructionsGroundPowerInputBlowerOutputElectrical access panelRaised Vent Electrical Access PanelRaised Vent Front ViewTo power wiri

11Installation InstructionsExample of Installation with Bottom Exhaust(Side View)REMP16 remote blowerConnect wires/conduit according to remote blower

12Installation InstructionsVerifying Proper Operation WARNING• Read the raised vent use and care manual completely before operation.• Install all of

13Wiring DiagramSTUDCHASSISGROUNDGROUNDPOWERINPUTBLOWEROUTPUTGNDL2 N1L1N2 GNDCOMCOMNONOUPLIMIT SWITCHDOWNLIMIT SWITCHCOM NCNONCNCREMOTE POTSNORKEL SWI

Dacor●600AntonBlvd.Suite1000CostaMesa,CA92626●Phone:(800)793-0093●Fax:(626)403-3130●www.Dacor.com

Installation Instructions ... 8Installation Preparation ...

1Important Information About Safety Instructions• The Important Safety Instructions and warnings in these instructions are not meant to cover all pos

2Important Safety Instructions• Do not install or operate a damaged appliance. If you receive a damaged appliance, contact your dealer or builder.•

3Product DimensionsProduct Specifications15"(38.1 cm)30"(76.2 cm)20”(50.8 cm)1 1/8”(2.9 cm)28" 3 prong groundedpower cordMotorcoverFron

4• The customer must supply 3 conductor wiring/conduit with minimum current carrying capacity of 8 Amps. to supply power to the remote or in-line blo

5Installation SpecificationsVerticalnon-combustiblesurface rear wallNotches required for some rasied ventinstallations, see cooktop installation instr

6Installation Specifications• When connecting the duct work to the back of the unit, the customer must supply a 3 ¼” X 10” rectangular transition to

7• On side exhaust installations, allow five inches of space on the side for the ADT2 exhaust transition plus addi-tional space for the duct attached