Dacor ER36D User Manual

Browse online or download User Manual for Cookers Dacor ER36D. Combined Configuration ER36D/ER48D and ERV

  • Download
  • Add to my manuals
  • Print
  • Page
    / 1
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
PLANNING
GUIDE
www.Dacor.com Phone: (800) 793-0093
Specications subject to change without notice.
Install all appliances according to accompanying installation instructions.
CI.6
ER36D, ER48D Range with ERV36-ER,
ERV48-ER Raised Vent
COMBINATION INSTALLATIONS
WARNING
Observe all governing codes and ordinances during planning •
and installation. Contact your local building department for
further information.
All appliances must be installed in accordance with the •
accompanying installation instructions.
CUTOUT DIMENSIONS
Range Model G H
ER36D 36 1/16” (916 mm)
33 1/2”
(848 mm)
ER48D 48 1/16” (1221 mm)
43 1/2”
(1102 mm)
*** Countertop depth is at the discretion of the customer, however,
the back of the control panel MUST be in front of the cabinet face for
safety.
G
10" (254 mm) Min.
to combustible side
walls above the range
(both sides)
non-combustible
Minumum Countertop Height:
30 1/4” (768 mm)
Maximum Countertop Height:
36 1/2” (927 mm)
rear wall recommended
Backsplash
3/8" (10 mm)
Min. flat countertop
overhang
H
2 13/16"
(71.4 mm)
3
CUTOUT FOR ER36D OR ER48D RANGE WITH RAISED VENT
(TOP VIEW)
APPROVED RAISED VENT MODELS
Raised Vent Model
For use with
Range Model
ERV36-ER ER36D
ERV48-ER ER48D
Stiffener
Cabinet face**
Countertop*
* IMPORTANT: See “CUTOUT WITH OPTIONAL ERV RAISED VENT”
for countertop cutout dimensions.
** IMPORTANT: Cabinet face must not stick out further than
back of control panel.
Back of
control
panel
ERV36-ER or
ERV48-ER
raised vent
ER36D or ER48D Range
3/8” Min. (10 mm)
space behind
raised vent
chassis to clear
stiffener
3/8” Min. (10 mm)
flat countertop overhang
required behind cutout
Countertop height:
30 1/4" (768 mm) Min.
36 1/2” (927 mm) Max.
RAISED VENT INSTALLATION
(SIDE VIEW)
***
Document # PGCI - 005
Revised 02/04/10 Page 1/1
Product tolerances: +/- 1/16” (+/- 1.6 mm) unless otherwise stated
Page view 0
1

Summary of Contents

Page 1 - COMBINATION INSTALLATIONS

PLANNINGGUIDEwww.Dacor.com Phone: (800) 793-0093 Specications subject to change without notice.Install all appliances according to accompanying

Comments to this Manuals

No comments