Installation InstructionsDistinctive® Built-in Dishwasher Model DDW24SDacor Part No. 105658 Rev. G
8Installation InstructionsInstallation Preparation WARNING• Before working on wiring for any electrical appliance, be sure the power has been turned
9Level the Dishwasher CAUTION• A level unit is very important to proper operation. Be sure to level the unit front to back and side to side.• Use ca
10Installation InstructionsInstalling the Unit in the Cabinet1. Position the dishwasher in front of the cabinet opening.2. Before sliding the unit i
114. Once the dishwasher is in place check to make sure all slack is pulled out of the power cable, water supply line and drain hose. Check to make s
12Installation Instructions4. Check for leaks under the dishwasher and under the sink. If any leaks are found, immediately push the STOP button and d
13Installation InstructionsAttaching the Anti-tip Brackets CAUTIONMake sure to anchor one anti-tip bracket on each side of the dishwasher.1. The anti
14Installation InstructionsInstallation Checklist WARNING• To ensure a safe and proper installation, the following checklist should be completed by t
15Notes
16Notes
Installation Instructions ... 7Verify the Package Contents ...7Installation Preparation ...
Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.comArt. No., 701313 Rev. 02
1Important Information About Safety Instructions• The Important Safety Instructions and warnings in these instructions are not meant to cover all pos
2Important Safety Instructions• Use this dishwasher only for its intended purpose as outlined in the use and care manual. It is not intended for comm
3Product SpecificationsDrain hoseDo not modify22 7/8” (63.2 cm)2” (50.0 cm)5 3/8” (13.7 cm) to7 3/8” (18.7 cm)Depth with door closedDepth dimensions a
4Grounding Instructions for a Permanently Connected ApplianceThis unit must be grounded to operate properly. It must be connected to a grounded metal,
5Dishwasher Cutout - Front ViewMinimum Door ClearancePreparing for InstallationCutout tolerances: +1/16” (+1.6 mm), -02” (5.1 cm) Min. clearancePrepar
6Preparing for InstallationPreparing the Drain CAUTIONKeep the factory installed high loop drain hose in place to ensure proper dishwasher operation.
7Installation InstructionsVerify the Package Contents• Remove all styrofoam and plastic wrap from the dishwasher. Be sure to remove the toe kick from
Comments to this Manuals