Dacor DYF42SBIWS User's Guide download pdf

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093

PLANNING

GUIDE

11.13

Water-Supply Requirements

• To function properly, the water dispenser and icemaker

need a cold-water pressure of 30 – 120 psi (207 – 827

kPa). A licensed plumber can answer questions about

water pressure.

• Install a shut-off valve between the refrigerator and water

supply. Use 1/4” copper tubing with compression nut and

sleeve. After connecting the tubing, check for leaks.

• Do not use a piecing type or 3/16” (5 mm) saddle valve

which will reduce water flow and clog more easily.

• The plumbing for the water line can come through the floor

flush with or from the back wall. The preferred location is

in a cabinet beside the refrigerator, preferably on the right.

Reverse-Osmosis Water System

Discovery

42” Wide, Built-In

Refrigerator with Dispenser

Document # PG11-019

Revised 01/31/17 Page 1/4

WARNING

• Observe governing codes and ordinances. Contact your local

building department for details as needed.

• Install this refrigerator per the directions in this document.

Electrical Requirements

• You must be able to plug the refrigerator power cord

directly into a grounded, non-GFCI electrical outlet. (Do

not use an extension cord, power strip, or 2-prong adaptor

to connect the refrigerator to its power source.)

• Do not use an outlet that can be turned off by a switch.

• A 115 V, 60 Hz AC only 15- or 20-Amp fused, grounded

electrical supply is required. Dacor recommends connect-

ing the refrigerator to its own dedicated circuit.

• The circuit must be protected by an proper-size fuse or a

circuit breaker.

Location Requirements

The refrigerator is designed for flush installation in a recess

between cabinets.

• The refrigerator should be at least 12” (30 cm) from heat

sources (e.g., ranges, cooktops, ovens, heaters) and away

from direct sunlight/humidity.

• Leave at least 1/2” (1.3 cm) of ventilation space around

the refrigerator.

• Do not install the refrigerator on a rug, carpeting, or any

kind of matting.

• Ensure the floor under the refrigerator is flat, level, and

strong enough to support 600 lbs (272 kg) without sag-

ging; do not install the refrigerator on a raised platform or

sub-flooring.

• Do not install the refrigerator in any kind of space where

the ambient temperature would be less than 50°F (10ºC).

IMPORTANT–Reverse Osmosis

• Water pressure from the household cold-water supply to a

reverse-osmosis system must be 40–60 psi (276–414 kPa).

• Pressure from a reverse-osmosis system to the refrigerator

inlet valve must be 30–120 psi (207–827 kPa).

DYF42SBIWS

IMPORTANT

Install copper tubing only in geographic regions where interior

temperatures remain above freezing (32°F/0°C).

1 2 3 4

DYF42SBIWS 1

Summary of Contents

Page 1 - DYF42SBIWS

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093PLANNINGGUIDE11.13Water-Supply Requirements• To function properly

Page 2

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093PLANNINGGUIDE11.14Discovery® 42” Wide, Built-In Refrigerator with

Page 3

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093PLANNINGGUIDE11.15Installing the Anti-Tip BracketsThese brackets a

Page 4

All specications subject to change without notice. www.dacor.com Ph. 800.793.0093PLANNINGGUIDE11.16DYF42SBIWSDiscovery® 42” Wide, Built-In Refriger

Dacor DYF42SBIWS User's Guide

Browse online or download User's Guide for Fridges Dacor DYF42SBIWS. Dacor DYF42SBIWS Planning Guide User Manual

Summary of Contents

More documents for Fridges Dacor DYF42SBIWS

Comments to this Manuals

Dacor DYF42SBIWS User's Guide

Browse online or download User's Guide for Fridges Dacor DYF42SBIWS. Dacor DYF42SBIWS Planning Guide User Manual

Summary of Contents

More documents for Fridges Dacor DYF42SBIWS

Comments to this Manuals

Related products and manuals for Fridges Dacor DYF42SBIWS