Service Test 28 – Actuator Switch
This test displays the current state of the dispenser actuator (paddle switch) as read by the Main Control board. Pressing the
Power Interrupt Button will display the current state of the switch.
on = Switch activated OF = Switch released
Service Test 29 – Cube Solenoid
This test will energize the cube solenoid. Pressing the Power Interrupt Button will energize the cube solenoid when the Dispenser
switch is also actuated.
Service Test 30 – Auger Motor
This test will energize the auger motor. Pressing the Power Interrupt Button will energize the motor when the dispenser switch is
also actuated.
Service Test 31 – Chute Solenoid
This test will energize the chute solenoid. Pressing the Power Interrupt Button will energize the chute solenoid.
Service Test 32 – Water Valve
This test will energize the water valve(s) for the dispenser. Pressing the Power Interrupt Button will energize the water valve so
long as the dispenser switch is activated.
Service Test 33 – Force Defrost and Exit
This test will initiate a defrost cycle and exit the Service Test Mode. Pressing the Power Interrupt Button will initiate the defrost
cycle.
Release the door switch to return to normal operation.
FoodSaver™ TEST MODE
To perform the built-in diagnostics that test the FoodSaver™ module, both door switches must be closed. Tape the fresh food
compartment door switch closed. With the door switches closed, the FoodSaver display should be blank.
To enter the FoodSaver test module, press and hold the Citrus and Produce keypads for five seconds.
The LCD should display –88 and be illuminated.
All keypads should be illuminated.
The fan should be off.
The damper should close
Wait seven seconds, touch the Citrus Keypad.
The fan will begin turning.
If the controller does not sense fan rotation, an F will be displayed.
The heater will energize.
If the control does not sense heater continuity, an H will be displayed.
The damper will open.
The display should be blank yet illuminated unless indicating an F or H.
The Citrus keypad should be illuminated.
Wait seven seconds, touch the Produce Keypad.
The control will test the thermistor circuit.
If the circuit is open, OC will show in the display.
If shorted, CC will show in the display.
The display should be blank yet illuminated unless indicating OC or CC.
The produce keypad should be illuminated.
Touch the Meat Keypad. (Not applicable to upper FoodSaver)
The meat keypad will illuminate.
Touch the Normal Keypad
This will exit the diagnostic mode.
The diagnostic mode will terminate if the refrigerator door switch is opened or if five minutes passes with no activity.
Continued… Dacor 42” and 48” Built-in Refrigerator Diagnostics (First Generation - Classic):
Models: EF42BDCBSS, EF42BNDBSS, IF42BNDBOL, IF42BDCBOL, EF48BDCBSS, EF48BNDBSS, IF48BNDBOL, IF48BDCBOL
Dacor Technical Assistance: 800-353-2267
PG: 29
(35 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals