Dacor EG366 User Manual download pdf (Page 14)

Verifying Proper Operation

WARNING

, Make sure that power to the e ectrical outlet is turned

Off at the circuit breaker or fuse box and that the gas

is turned off at the gas supply valve before proceed-

ingl

i The c0oktop must be propedy grounded at el! times

when electrical power is applied:

Prior to operating the cooktop, read the accompanying use

and care manual carefully.

Make sure all the

cooktop burner con-

trols are in the OFF

position.

OFF HIGH LOW

Connect the power

cord to the electrical outlet.

Turn on power to the electrical outlet at the circuit

breaker or fuse box.

Gently push in and turn one burner control knob at a

time counterclockwise to the HIGH position. Verify that

the associated burner igniter sparks, then return the

knob to the OFF position. Repeat for all of the remain-

ing control knobs.

Turn on the gas supply valve.

Perform the following ignition test for all of the burners:

• Push in and turn one of the control knobs counter-

clockwise to the HIGH position. Only the igniter for

the selected burner will spark. It may take up to four

seconds for the gas to ignite, at which time the ignit-

er will stop sparking. If ignition does not occur within

four seconds, turn the knob to the OFF position, wait

for at least five minutes to allow any gas to dissipate,

then repeat the test.

• Once the burner lights, the control knob can be rotat-

ed counterclockwise from HIGH to LOW to adjust the

flame height progressively.

When the unit is installed properly, the flame will be

steady. It will also have a sharp, blue inner cone that

will vary in length pro-

portional to the burner

size. The flame will be

reduced by the Smart

Flame TM feature under

the grate fingers to

increase grate life.

Normal Flame

Appearance

NOTE: If the cooktop does not operate properly, follow

these troubleshooting steps:

• Verify that power and gas are supplied to the cooktop.

• Check to make sure that the power plug is connected

to the electrical outlet and that power is turned on at

the circuit breaker or fuse box.

• Check to make sure that all burner parts are properly

seated.

• If the burner continues to spark after ignition without

stopping, have a licensed electrician check the electri-

cal outlet for proper grounding or reversed polarity.

• Repeat the burner ignition test.

If the appliance still does not work, contact Decor

Distinctive Service at (877) 337-3226. Do not attempt to

repair the appliance yourself. Be sure to have the model

and serial numbers available when you call. See the inside

cover for location.

Dacor is not responsible for the cost of correcting problems

caused by a faulty installation.

12 c_acar

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments

Dacor EG366 User Manual Page 14

Comments to this Manuals

Related products and manuals for Cookers Dacor EG366