Dacor EG366 User Manual download pdf (Page 5)

WARNING

observe all g0verning c0des and ordinanCes during

planning and installation, Contact your local building

department for further information.

To prevent an electric shock hazard, the power sup-

ply must meet the specifications stated below.

The electrical and gas supply data on this page is for refer-

ence only. If the requirements below do not agree with the

product data label, use the data on the product data label.

Electrical Requirements

The electrical installation, including minimum supply

wire size and grounding, must be done in accordance

with National Electric Code ANSI/NFPA 70 and local

codes and ordinances. A copy of this standard may be

obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02269-9101

The correct voltage, frequency and amperage must be

supplied to the electrical outlet according to the product

data label located on the bottom of the chassis.

• The electrical outlet must be installed by a licensed

electrician.

ELECTRIC CIRCUIT REQUIREMENTS

Circuit Required ' Total Connected Load

120 Vac 60 Hz,

15 Amp. (3 wire)

0.25 Amp @ 120 Vac, 60 Hz

Gas Supply Requirements

Check your local building codes for the proper method

of installation. In the absence of local codes, this

appliance should be installed in accordance with the

National Fuel Gas Code ANSI Z223.1/NFPA 54. The

gas service must be installed by a qualified profes-

sional

Be certain that the cooktop being installed is correct for

the gas service being provided (natural gas or LP gas).

Also, if operating the cooktop at an altitude above 4000

ft. (1219 m) make sure it is equipped for high altitude

operation. See the inside cover for more information.

An external manual shut-off valve must be installed

between the gas inlet and the cooktop for the purpose

of turning on or shutting off gas to the appliance.

The factory provided regulator shipped with the appli-

ance must be installed in the gas line that runs from the

gas shut off valve to the cooktop gas inlet. Use only the

regulator provided. The regulator inlet accommodates

a 3/4" gas supply line and is also compatible with a

1/2" house gas supply. The inlet to the cooktop itself is

equipped with a 3/4" male NPT fitting.

GAS SUPPLY PRESSURE REQUIREMENTS*

_ Manifold" Minimum Gas

_as lype Pressure sUpply Pressure

Natural Gas 5" Water Column 6" Water Column

10" Water

Propane (LP) Column 11"Water Column

Maximum gas supply pressure for all models is 1/2 p.s.i.

Product Dimensions

COOKTOP WIDTH (A)

EG366 35 7/8" (911 mm)

EG486 47 7/8" (1216 mm)

, 28" (711 mm) , Triml,

7/16

•, 27" (686 mm) "1(11 mm)

"1/

4 26" (660 mm) _ thick

1' 1 1/2" (38 mm) cooking surface--_'

height (grate level)above ,,q l ,l 7 3/4"

countertop ', ,_ ,' (197 mm)

. _{_

L 5/8"

4" (102 mm) (16 mm)

Power cord

32" long

3/4" gas inlet, connects to regulator from --

bottom or rear of unit, end is recessed

2" (51 mm) from chassis bottom

SIDE VIEW

Product tolerances: +1/16" (+1.6 mm) unless otherwise

noted.

I_mC'l_tt, 3

1 2 3 4 5 6 7 8 9 10 ... 18 19

Comments to this Manuals

No comments

Dacor EG366 User Manual Page 5

Comments to this Manuals

Related products and manuals for Cookers Dacor EG366