Dacor MDW24S Specifications download pdf (Page 11)

Locate the foam support between the motor and the

liner on the bottom of the unit. Use two hands to rotate

and slide the foam down and to the left to remove it.

Discard the foam.

Foam support

7. Remove the four (4) screws at the front of the access

cover. Tilt the access cover and pull it forward to

remove it.

Junction box

Access cover

Locate the water inlet

valve on the bottom of the

dishwasher. It has a 3/8"

NPT female fitting. Wrap

the threads on the 90°

elbow (not included) with

thread seal tape or apply

joint compound. If using

tape, wrap it in the same

direction as the elbow

threads. Thread the elbow

into the water inlet valve.

Tighten the elbow with a

wrench, leaving it pointing

toward the rear of the

dishwasher. To prevent

damage, do not over

tighten.

Level the Dishwasher

CAUTION

A level Unit is very imp0rtant for proper operati0n: Be sure

to level the unit front to back and side to side. ...............

Measure the height of the cabinet opening from the

underside of the countertop to the floor.

Move the dishwasher to the front of the installation

area.

Use the included spanner wrench to adjust the leveling

legs. Make sure the dishwasher height fits into the

enclosure with 1/4" clearance at the top.

Open the door and remove the bottom rack. Check that

the dishwasher is level from front to back by placing a

level inside, on the bottom of the tub. Check to make

sure the dishwasher is level side to side by placing the

level on the top front of the tub.

Top front of tub Level

®@@®® @@®11@

5. Adjust the legs up or down until the dishwasher is level.

I_mCD_ 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Dacor MDW24S Specifications Page 11

Comments to this Manuals

Related products and manuals for Dishwashers Dacor MDW24S