Dacor OB52 User Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
17
If the second or third attempt to ignite the burner is 6.
not successful then turn all burner controls to the OFF
position.
If the grill or cooktop fails to operate properly, ensure 7.
that the electrical power supply and gas supply are
turned on and that all installation steps have been care-
fully followed. Check the ground fault interrupter(s) on
the electrical outlet(s) to make sure that it is not tripped.
Push the black button to reset.
If the grill still will not light, turn off the main gas line 8.
control valve or LP tank control valve and contact the
Dacor Customer Service Team at (800) 793-0093, to
schedule a service call.
Installation Checklist
WARNING
To ensure a safe and proper installation, the follow-•
ing checklist should be completed by the installer
to ensure that no part of the installation has been
overlooked.
Proper installation is the responsibility of the hom-•
eowner. The importance of proper installation of your
Dacor Outdoor Grill cannot be over emphasized.
Is the electrical outlet for the appliance grounded and
located according to these instructions and in accor-
dance with all applicable electrical codes for outdoor
appliances?.
Is the gas service for the appliance located and
installed according to these instructions and in accor-
dance with all applicable codes?
Has the gas supply inlet pressure been measured to
ensure that it does not exceed the maximums and
meets the minimum stated in these instructions?
Is the appliance secured to the cabinet or cart?
Are the grease tray, flame spreaders, grates and, if
applicable, burner heads and caps properly installed
according to these instructions?
Has proper operation been verified? Did the installer
check the gas supply for leaks?
Have any problems been noted on the warranty card
or during the on-line warranty activation? Has the war-
ranty been activated on-line or the warranty card filled
out completely and mailed?
With the tank shelf open, connect the power cord from 2.
the outdoor grill and the warming oven (if equipped with
one) to the electrical outlet on the back panel inside the
cart.
Connect the rotisserie motor power cord to the electri-3.
cal outlet on the back side of the cart.
Power Connection - Cabinet Installations
Connect the appliance(s) to an electrical outlet that •
meets the specifications in the Planning the Installation
section.
The rotisserie motor should be plugged into the same •
outlet or an alternate 120 Vac outlet on the same circuit
as the appliance.
Verifying Proper Operation
Lighting Instructions
Read and understand the accompanying use & care 1.
manual prior to cooking with this appliance. The use
and care manual contains additional important safety,
service and warranty information.
No adjustment of burner settings is required. All valves 2.
and air mixture shutters found in this appliance have
been factory preset.
With the main gas supply valve on, turn all burner 3.
knobs to the HIGH position for approximately 20 sec-
onds to allow the air in the system to purge from the
grill and cooktop side burners.
Once the gas has filled the lines the automatic elec-4.
tronic ignition system should ignite the burner. If the
system burners do not ignite within 20 seconds turn all
burner controls to the OFF position. Wait five minutes
and attempt the ignition process again.
Visually check the burner flame for proper operation. 5.
Proper flame operation will show a steady, soft blue
color and stable flame.
Installation Instructions
Push to reset
Electrical Outlet with Ground Fault Interrupter
Page view 18
1 2 ... 14 15 16 17 18 19 20

Comments to this Manuals

No comments