English 29
Installation instructions
3. Open the door fully. If the door does
not open 90°, repeat Steps 1 – 3.
4.
Flip the hinge locks 90° inward to lock
them. [See graphic A in Remove oven
door(s), Step 1 for the locked position.]
5. Close the oven door. (With the hinges
properly installed and the door
closed, there is an even gap between
the door and the control panel. If one
side of the door is lower than the
other, the hinge on the low side is not
properly installed.)
6. Connect the wire harness.
Comments to this Manuals