Dacor MRE30 Specifications download pdf (Page 7)

Verifying Proper Operation for Gas

and Dual Fuel Ranges (RSD)

WARNINGS:

1. The range and shut-off

valve must be disconnected

from the gas supply piping

during any pressure testing

exceeding 1/2 psi (3.5kPa).

2. The range must be isolated

from the gas supply piping

by closing the shut-off valve

during any pressure testing at

or below 1/2 psi (3.5 kPa).

Before beginning the test procedure, ensure

that all cooktop control valves are in the “OFF”

position, and all burner rings, burner caps, and

grates are properly positioned on the top frame.

Turn on the gas supply at the shut-off valve.

Turn on the power supply to the range. Set the

time of day by pressing the “CLOCK” key and

then pressing either of the “TIME•TEMP” keys

to advance or reduce the time in the display

in the desired setting. Press the “BAKE” key.

Select a temperature of 350˚F by pressing the

“TIME•TEMP” “+” key. The display should show

“BAKE ON”.

After approximately 30 seconds, the lower

ignitor should glow red and the burner should

be on. Press the “CANCEL•SECURE” key

to stop the oven heating process. Press the

“BROIL” key and the “TIME•TEMP” “+” key.

After approximately 30 seconds the broil ignitor

should glow red and the broil burner should be

on. Press the “CANCEL•SECURE” key to turn

the broiler off.

Test each top burner separately by pressing

and turning one control knob at a time

counterclockwise to the “HIGH” position. All

ignitors will spark continuously, but only the

burner with gas flowing to it will ignite. (It will

take approximately 4 seconds for ignition

to occur, at which time the ignitors will stop

sparking. If ignition does not occur within 4

seconds, turn off the knob, wait for at least

2 minutes to allow any gas to dissipate, then

repeat this ignition test.) The control knob

can then be rotated, counterclockwise, from

“HIGH” to “LOW” to adjust the flame height

progressively. Repeat the ignition test for all

burners.

When installed properly, the flame will be steady

and quiet. It will also have a sharp, blue inner

cone that will vary in length proportional to the

burner size

Verify Proper Operation for Electric

Ranges (RSE and MRE)

Before beginning the test procedure, ensure all

cooktop control valves are in the off position.

For electric cooktops, rotate one surface element

knob at a time, counterclockwise, to the “HI”

position. Within 5 seconds, the element should

be fully energized and glowing red. Verify that

the residual heat indicator light comes on in

conjunction with the proper element, within

approximately 30 seconds. Return the knob

to the “OFF” position. Repeat for all surface

elements. (Note: The right front element is a

dual coil element. Clockwise rotation from

“LO” to “HI” will energize the inner coil only.

Counterclockwise rotation from “LO” to “HI”

will energize both the inner and outer coils

together). For MRE range top, turn an element

on, tap the “ON/OFF” key then tap the up arrow

for the desired element. The element will come

on at a setting of “5” and may be adjusted up

or down by pressing the appropriate key. To

activate the Dual Element, tap the “ON/OFF”

key then tap the Dual Element Indicator to

activate the outer ring of the element. It will

come on at a setting of “5”, then tap the up

indicator for desired temperature setting. To turn

an element off, tap the “ON/OFF” key. You may

turn off all active elements at the same time by

tapping twice on the Dacor logo located below

the controls.

Gas and Dual-Fuel Range Control Knob

RSE Range Control Knob

MRE Range Controls

NOTES:

If either the oven or cooktop does

not operate properly, follow these

troubleshooting steps:

1. Verify that power and gas are

supplied to the range.

2. Check the electrical

connections and gas supply

to ensure that the installation

has been completed correctly.

3. Repeat the above bake test or

burner ignition test.

4. If the appliance still does

not work, contact an

authorized DACOR service

company at (800) 772-7778.

Do not attempt to repair the

appliance yourself. DACOR

is not responsible for service

required to correct a faulty

installation.

CANCEL • SECURE

ON/OFF

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Dacor MRE30 Specifications Page 7

Comments to this Manuals

Related products and manuals for Small kitchen appliances Dacor MRE30