Dacor REMP3 Specifications download pdf (Page 4)

Important Safety Instructions

• Do not install or operate this unit if it has been dam-

aged, dropped, has damaged electrical wiring or

is not working properly. If you receive a damaged

product, immediately contact the dealer or builder.

• Install or locate this appliance only in accordance

with these installation instructions and the Dacor

hood or downdraft vent installation instructions.

Improper installation, adjustment, alteration, service

or maintenance can cause serious personal injury or

property damage.

• Before installing or servicing the blower, make sure

that power to the wiring is turned off at the circuit

breaker or fuse box. Make sure that the service

panel is locked or tagged to prevent power from

being switched on accidently.

• A minimum of two people are required to safely

install this appliance.

• The installer must show the customer the location

of the fuse or circuit breaker panel so that the cus-

tomer knows where and how to turn the power off.

• To reduce the risk of electric shock or fire, the total

combined current draw of the in-line blower and the

hood or downdraft vent must not exceed the maxi-

Product Specifications

WARNING

General Safety Precautions

To reduce the risk of fire, electric shock, serious injury or death when using this blower, follow basic safety precautions,

including the following:

mum rated input current of the hood or downdraft

vent.

• Never allow the filters or vent openings on the hood

or downdraft vent to become blocked or clogged.

Do not allow foreign objects, such as cigarettes or

napkins, to be sucked into the vent holes.

• Tape all duct joints securely to prevent combus-

tion by-products, smoke or odors from entering the

home. Doing so will also improve system efficiency.

• Do not route electrical wiring near hot surfaces.

• Do not ground the appliance with the neutral (white)

house supply wire. A separate ground wire must be

utilized.

• To prevent a damaged or non-functional system,

complete electrical connections properly. Follow

the wiring diagrams carefully in the hood or in-line

blower installation instructions to ensure a proper

installation. After installation or service, make sure

that all blower wires are tightly connected to their

respective terminals.

WARNING

Electrical Supply Requirements

• The power for this blower is supplied via 1/2” 3-wire

wiring/conduit (not included) by an approved Dacor

hood or downdraft vent. The wiring/conduit is installed

between the hood or downdraft vent and the blower

and shall be terminated on each end by a 1/2” UL certi-

fied strain relief. The power is turned on and off by the

power switch on the approved ventilation device.

• The correct voltage, frequency and amperage must be

supplied to the hood or downdraft vent and the blower

from a grounded, single phase circuit that is protected

by a properly sized circuit breaker or time-delay fuse.

The circuit must have the capacity to supply the com-

bined power requirements for the hood or downdraft

vent and the in-line blower. See the installation instruc-

tions for the hood or downdraft vent to determine total

power requirements in combination with the blower

electrical specifications.

Model* Power Requirements** Blower Rating***

REMP3 120 Vac, 60 Hz., 3.8 Amp. 600 CFM

REMP16 120 Vac, 60 Hz., 2.7 Amp. 1000 CFM

* All models are thermally protected.

** In addition to the hood or downdraft vent.

*** Nominal rating at 0 inches static pressure. See

Technical Data section for actual ratings.

• The above specifications are for reference only, See

the data label on the blower for exact specifications.

If the above specifications vary from the label on the

blower, use the data on the blower label.

• It is the owner’s responsibility to ensure that the power

supply is installed by a licensed electrician. The electri-

cal installation must comply with the latest revision of

the National Electric Code ANSI/NFPA 70 (latest revi-

sion) and local codes and ordinances. A copy of the

specification may be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, Massachusetts 02269-9101

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Dacor REMP3 Specifications Page 4

Comments to this Manuals

Related products and manuals for Small kitchen appliances Dacor REMP3