Dacor MDH24 Specifications

INSTALLATION INSTRUCTIONS24-INCH DISHWASHERFor use with models: ED24, ID24, MDH24, MDV24, PD24AG, PD24BK,PD24BU, PD24GN, PD24SG, PD24TSPart No. 101891

ELECTRICALCONNECTION(Continued)13. Feed the electric wire or cord into the utility hole in theside of the cut-out. Pull all of the slack out of the wi

PLUMBING CONNECTIONS1. Connect one end of the 3/8" flexible braided fill hose tothe water supply valve.2. Route the hose through the utility acce

INSTALLING THE UNIT IN THECABINET (continued)NOTE: The leg nuts can be removed to make thedishwasher lower. To do so:0 Turn the leg until it comes out

DRAIN LINE INSTALLATION.2.3.Connect the flexible drain line to the air gap or connectit directly to the waste tee or disposal (see below).For installa

VERIFYING PROPEROPERATION []Pre-verification Check ListConfirm that the main power supply (at the circuitbreaker panel or fuse box) is off.Remove all

INSTALLATION INSTRUCTIONS

Before You Begin ... 1Important Safety Instructions ...

To reduce the risk of fire, electric shock, serious injury or death when using the dishwasher, follow basic safetyprecautions, including the following

TECHNICALWater Pressure 20 to 120 psi (138 - 827 kPa)Water120°F, minimumTemperature15A, 120 Vac, 60 Hz dedicated,Power grounded, circuit. See the mode

4 _aCD_

PREPARING THE LOCATIONCarefully check the location where the dishwasher is to beinstalled. Put it in a location with convenient access. Makecertain th

POWER SUPPLYPREPARATION PLUMBING PREPARATIONThe water pressure must be between 20 and 120 psi(138-827 kPa). The household hot water heater shouldsuppl

VERIFYTHE PACKAGE CONTENTSNOTE: Model ID24 ships without a front panel. It isdesigned for the installation of an integrated front panel thatmatches th

ELECTRICALCONNECTION..6.Remove the dishwasher junction box cover screw. Thejunction box is mounted to the dishwasher chassisbelow the door.r _Junction