Dacor ER36D-C Troubleshooting Guide download pdf (Page 15)

Page 9-1

SECTION 9 - COMPONENT REPAIR

Section 9 - Component Repair

Door Gasket (seal)

Remove the oven door. See the Door Removal

section on page 8-1.

Lay the door on a flat, padded surface with

the door gasket A facing up.

emove the gasket by grasping sections of it

and pulling up.

Insert the self-locking tabs on the

replacement gasket into the holes on the

oven door. Check to make sure that all of the

self-locking tabs are firmly in place by pulling

gently on the gasket.

Reinstall the oven door. See the Door

Installation section on page 8-2.

•

DANGER

Turn off electrical power at the main power supply and the gas supply at the supply valve

before servicing the range. Failure to turn off electrical power and the gas supply to the range

will result in a electric shock and explosion hazard.

•

Door Component Repair

WARNING

Do not attempt to disengage the hinge locks on the door while it is removed from the oven. The

hinge springs could release, causing personal injury.

Do not lift or carry the oven door by the door handle.

•

Door Handle (ER48D)

Remove the oven door. See the Door Removal

section on page 8-1.

Lay the door on a flat, padded surface with

the door gasket facing up.

Remove the two (2) screws B in the top

corners of the door

Grasp the door with one hand and pull up.

Pull the door handle out from underneath.

To reinstall the door handle, grasp the door

with one hand and pull up. Hold the handle in

position on the front. Lower the door onto the

padded surface.

Replace the two (2) screws in the top corners

of the door and tighten into place. Do not

over-tighten the screws. The front door glass

could crack.

Reinstall the oven door. See the Door

Installation section on page 8-2.

•

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comments to this Manuals

No comments

Dacor ER36D-C Troubleshooting Guide Page 15

Comments to this Manuals

Related products and manuals for Cookers Dacor ER36D-C