Dacor DOC30M977DS Installation Manual download pdf (Page 17)

English 17

Installation requirements

• Connect directly to the circuit-breaker box (or fused disconnect) through the

flexible, armored or nonmetallic sheathed, copper cable with grounding wire. (See

Electrical connection.)

• Flexible conduit from the oven should be connected directly to the junction box.

• Fuse both sides of the line.

• Do not cut the conduit. The conduit length lets the oven be pulled out for service.

• A UL-listed or CSA-approved condui

t connector must be provided.

• If the house has aluminum wiring:

– connect a section of solid copper wire to the ends of the flexible conduit leads.

– connect the aluminum wiring to the added section of copper wire using special

connectors/tools designed and UL-listed for joining copper to aluminum.

• Follow the electrical connector manufacturer’s recommended procedure.

Aluminum/copper connection must comply with local codes and industry-accepted

wiring practices.

For power requirement for model DOC30M977D refer to the following table.

Model 240 VAC 208 VAC

DOC30M977D* 8.9 kW 6.7 kW

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 95 96

No comments

Dacor DOC30M977DS Installation Manual Page 17