Dacor Dishwasher Service Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
Page 4-1
DaCor builT-in Dishwasher serviCe Manual
Safety Precautions
Always turn off the electric power supply before servicing electrical components, testing with an
ohmmeter, or replacing parts. Refer to Safe Servicing Procedures at the front of this manual before
servicing the dishwasher.
All voltage checks should be made with a voltmeter having a full scale range of 130 volts or higher.
After service is completed, be sure all safety-grounding circuits are complete, all electrical connections
are secure, and all access panels are in place.
If the repair on this product requires the removal of door panel, liner, or the cabinet, you may find
exposed sharp edges. Removing the door could expose sharp edges - use extreme caution.
Care must be taken to avoid injury while working with exposed sharp edges. It is highly recommended
that protective clothing and gloves are worn while performing service to this product.
Door Panel
In order to access the electronic controls, the outer door panel
must be removed from the door assembly.
Disconnect dishwasher from power supply.
The outer door panel is mounted to the inner door panel by
Phillips head screws (Figure 22).
Removing the outer door panel will expose sharp edges on
the inner door panel.
Be sure to support outer door as screws are removed to
prevent damage to outer panel and dishwasher.
Remove wiring harness from control and ground connection
on door panel.
The outer door panel is disconnected.
Control
Disconnect dishwasher from power supply.
Remove outer door panel (see Service and Disassembly
section labeled Door Panel).
Lay outer door panel face down on a protective surface.
Compress plastic retainers with a pair of pliers to release
the electronic control from carrier panel (Figure 23).
Lift control from mount.
With the control removed, pull protective shield back to
free ribbon from keypad assembly.
Remove two screws holding outer door reinforcement to
outer door panel.
These screws also hold the door handle in place.
Do not drop door handle.
Remove this reinforcement to gain access to keypad assembly.
To install parts, reverse procedure.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Section 4 - Service & Disassembly
FIGURE 22
PLIERS ON MOUNT – FIGURE 23
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Comments to this Manuals

No comments