Dacor Dishwasher Service Manual download pdf (Page 7)

Rinse Phases

The first rinse phase follows the pre-wash portion of a wash cycle. During this rinse phase, the motor

ramps up by 100RPM/second to full speed (2800RPM). Once at full speed, however, the motor will cycle

between 1600RPM and 2800 RPM throughout the rest of this rinse phase. This motor action aids in the

removal of food from the dishes so it can be filtered from the water.

The final rinse phase begins, following the end of the main wash. Rinse agent is added to the

water during the final rinse. Rinse agent speeds drying, removes water spots, and water streaks

from glassware.

If the Sanitize option has been chosen, the control will pause the time remaining to allow the heater to

increase the water temperature to 155°F. This delay will last up to 30 minutes before resuming the rest

of the cycle. The Sanitize outer ring will light following the wash only if 155°F is achieved.

FIGURE 5

Condensate Drying

This dishwasher is designed and equipped with a

condensate drying system. Steam is drawn from the

tub by the condensate fan and forced through the

condensate duct. As it flows through the condensate

duct, the cool surface of the baffles condenses the

steam into water allowing the now cooler and drier

air to exit into the tub through the condensate vent.

The condensate vent is also the exit for the water

from the condensate duct into the

tub to be drained.

This circulation starts before the unit has completed

draining and continues for the rest of the drying

phase of the wash cycle. The air intake and

condensate vent are shown in Figure 6.

The final operation of the wash cycle energizes the

fill valve long enough to allow the soil sensor to

recalibrate itself with fresh, clean water.

Page 2-4

seCTion 2 - oPeraTion

Blower Fan

Air Duct

Intake

Side Vent

Air Return

1 2 3 4 5 6 7 8 9 10 11 12 ... 33 34

No comments

Dacor Dishwasher Service Manual Page 7