Dacor ER3OD User Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
Setting the Time
IM PORTANT:
The clock cannot be set during delay timed cooking or
if one or both timers are in use.
After a power failure, the time on the display may
flash, indicating that the time may not be correct.
To set the time:
i. Press the CLOCK key. "TIME" will flash on the dis-
play.
2. Enter the current time and press START. For exam-
ple: For 12:08 Press 1-2-0-8 on the keypad, then
START.
IMPORTANT: Afterpressing the clock key, you must
enter the time and press START soon afterward. Ifyou
wait longer than sixseconds between pressing keys, the
display will go back to the original setting.
t
Clock key
24/12 Hour Clock (Military Time)
The range is set to 12-hour (non-military) time at the fac-
tory. 24- hour time is also known as military time.
1:36 P.M. = 13:36 military time.
Setting the Temperature Scale
The control panel allows you to select the temperature
scale (Fahrenheit or Celsius) it uses to display the cooking
temperature. The oven is preset at the factory to Fahren-
heit.
To change the temperature scale:
1. Press and hold the BROIL key for six seconds.
2. The display will indicate the temperature scale the
control panel is currently set to, "F" or "C'.
3. Press the SELF-CLEAN key within six seconds to
change the temperature scale. To leave the setting as
is, do not touch any keys.
4. Wait six seconds. The control panel will go back to
the regular clock display, set to the new temperature
scale.
Control Panel Position
The control panel can be swiveled to a 50 ° angle for
easier viewing and use.
To
1.
2.
To
i.
2.
pivot the control panel:
Push in on the bottom of the control panel where it
says "PRESS HERE". The control panel will pivot up.
Pull up on the bottom of the control panel housing
(under "PRESS HERE") until it locks in place.
put the control panel back in the vertical position:
Pull up on the bottom of the control panel housing
(under "PRESS HERE") to unlock it.
Push in where it says "PRESS HERE" until it locks into
the vertical position.
If you want to switch the clock to 24 hour time or
switch from military back to regular time:
1. Press and hold the clock key for six seconds. The
display will indicate the mode the clock is currently set
to, 12 HR or 24 HR.
2. Press the SELF-CLEAN key within six seconds to
change the clock mode. To leave the setting as is, do
not touch any keys.
3. Wait six seconds. The control panel will go back to the
regular clock display, set to the new time standard.
If you have set the clock to 24 hour time, the keypad
will allow you to enter military time when setting the
clock.
Press here
9
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments